Trail and ultra runners plan altitude blocks around two kinds of race: races near sea level, and mountain races held at elevation.
The first is the one road cyclists, triathletes and trail runners share: an altitude block timed before an event near sea level. The second is specific to mountain races: time at simulated altitude before travelling to a race held at elevation, as one part of race preparation. This matters little to the road cyclist racing in Belgium or the 70.3 athlete racing in Florida. It matters to a trail runner targeting Hardrock, Leadville, UTMB, or another mountain ultra.
This article walks through both, the practical protocol structure for trail and ultra runners, and the race-week considerations that apply when a target race itself sits above 2,500m.
Two Kinds of Target Race
The road cyclist, the 70.3 athlete, and the marathon runner racing in low-altitude cities plan one thing: an altitude block timed to finish before a race near sea level.
For the trail and ultra runner whose target race sits at altitude, the same block also means 4 to 6 weeks of nights at 2,500m before travelling to the race.
Races Near Sea Level
Trail and ultra running is overwhelmingly aerobic. A 50km mountain race runs 4 to 8 hours for a competitive amateur. A 100-miler runs 16 to 35 hours. A 200-miler can run 50 to 100 hours.
For these races, the block is planned like any other: 8 to 10 hours a night at 2,500m for 4 to 6 weeks, finishing a planned number of days before race day. The right number of days varies between athletes.
Races Held at Elevation
The second use applies to trail and ultra runners targeting races at elevation, which covers much of the global mountain ultra calendar.
Hardrock 100 averages 11,000 feet (3,353m) across 102.5 miles, with 13 passes between 12,000 and 13,000 feet (3,658m to 3,962m) and a high point at Handies Peak of 14,048 feet (4,282m). Leadville 100 starts and finishes at 10,160 feet (3,097m), drops to 9,219 feet (2,810m) at its lowest, and tops out at Hope Pass at 12,532 feet (3,820m). UTMB peaks above 2,500m at multiple points across the course. Cocodona 250 sits between roughly 4,000 and 7,500 feet (1,219m to 2,286m) for most of its length but with sustained sections above 7,000 feet.
At these heights there is much less oxygen than at sea level. Simulated altitude does not replace a conservative ascent plan or advice from your doctor.
A trail runner who has slept at 2,500m for the previous 4 to 6 weeks arrives at the race with that time at simulated altitude already done, as one part of race preparation.
The Major Mountain Ultra Calendars
The global mountain ultra calendar concentrates around several regional circuits, each with altitude profiles worth understanding.
The North American circuit centres on the Rocky Mountain races. Hardrock 100 in Silverton, Colorado at an average of 11,000 feet. Leadville 100 with its sustained miles above 9,000 feet. The Bear 100 in Utah and Wyoming. The Wasatch Front 100. The Bighorn 100 in Wyoming. Cocodona 250 in Arizona. Run Rabbit Run in Steamboat Springs, Colorado. Most of these races sit at or above the 2,500m threshold for sustained sections, with peak points ranging from 3,800m to 4,300m.
The European circuit centres on UTMB and its sister races, plus the Italian and Spanish Pyrenean events. UTMB peaks above 2,500m at multiple points across its 171km. TDS, CCC, and OCC follow similar profiles within the Mont Blanc massif. Diagonale des Fous on Réunion Island runs to 2,300m. Tor des Geants in the Italian Alps spends sustained time at altitude across its 330km. The Lavaredo Ultra Trail in the Dolomites peaks at similar elevations.
The smaller mountain race calendar covers shorter mountain races where altitude exposure is significant but cumulative duration at altitude is shorter. Pikes Peak Marathon at the summit at 4,302m. Ultra-Trail Australia in the Blue Mountains. Ultra-Trail Cape Town. The Speedgoat 50K. The Telluride Mountain Run.
For each of these races, the altitude profile decides which kind of planning applies. The higher the race, the more the travel and arrival plan matters.
Running the Protocol at Home
Most trail and ultra runners run Sleep Cloud only, without the Training Cloud daytime sessions at altitude that cyclists and triathletes commonly add. The reason is structural. Trail runners typically train outdoors on real terrain rather than on indoor turbo trainers, which makes daytime interval sessions at altitude less natural to integrate into the training programme.

The Sleep Cloud Altitude System handles the entire altitude protocol cleanly for most trail runners. The athlete sleeps at 2,500m every night for 4 to 6 weeks, accumulating the 300-hour cumulative dose used in published protocols. Daytime training continues at sea level on the existing programme, with the descent each morning preserving training quality across the block.
The Box Altitude App tracks cumulative exposure session by session, which matters for runners scheduling structured blocks toward priority races and the 300-hour benchmark.
Race-Week Timing for Mountain Ultras
For trail and ultra runners targeting mountain races, race-week timing has additional considerations beyond the usual question of when to race after a block.
Start with the sea-level question. There is no single best day to race after altitude. One common coaching approach is to race about 7 to 14 days after the block ends; some coaches favour racing earlier, and others after two to three weeks. The best day varies between athletes, so for a sea-level race, rehearse the timing before a lower-priority race first, keep a record of how you respond, and taper appropriately for the main event. For the coaching advice and the studies behind this, see what the evidence says about race timing after altitude.
For mountain races, an additional consideration is travel and time on site. Most ultra runners arrive at the race location 3 to 7 days before the start. The athlete who has been sleeping at 2,500m at home arrives with that time at simulated altitude done. Plan the days on site as part of a conservative ascent plan.
Before You Start a Block
Speak to your doctor about a blood test before an altitude block.
When the Protocol Doesn't Translate
Two failure modes are common across trail and ultra runners specifically.
The first is training-quality compromise during high-volume blocks. Trail and ultra runners typically run 12 to 25 hours per week of training, with much of that volume occurring at zone 2 efforts. The "train low" half of LHTL applies. Athletes who attempt to train at meaningful elevations during the block lose the training quality that the protocol depends on, and the block often fails to convert to performance.
The second is unrealistic block timing. Trail runners targeting late-season mountain ultras (autumn UTMB, late-summer Hardrock, October Cocodona) sometimes attempt to run the altitude block too late in the calendar, so the block is cut short or race day arrives sooner after it than planned. Work back from the race date: the 4 to 6 week block, plus the gap before race day you plan to use, ideally one you have rehearsed before a lower-priority race.
The Bottom Line
Trail and ultra runners plan altitude blocks around races near sea level and mountain races held above 2,500m. The block is the same: 8 to 10 hours a night at 2,500m for 4 to 6 weeks.
For runners targeting Hardrock, Leadville, UTMB, or another mountain ultra, the travel and arrival plan matters as much as the block.
Box Altitude's partnership with the Queensland Academy of Sport connects the brand to the AIS-affiliated tradition that produced the protocol framework trail runners now use, and the Sleep Cloud Altitude System delivers the consistent overnight exposure that the protocol requires across the 300-hour benchmark.
For trail and ultra runners running serious altitude protocols at home, the system handles the protocol delivery cleanly. A check with your doctor comes first. The dose and the race timing are what you plan.
Medical Disclaimer
The information in this article is for educational purposes only and does not constitute medical advice, diagnosis, or treatment. Individual responses vary by health status, medical history, age, and fitness level. Before commencing any altitude protocol, consult a qualified medical practitioner or sports physician, particularly if you are pregnant, have cardiovascular or pulmonary conditions, haematological disorders, are recovering from surgery or injury, or are taking prescription medications. Box Altitude products are designed for healthy adults and are not medical devices intended to diagnose, treat, cure, or prevent any disease. Any persistent severe symptoms during altitude exposure warrant immediate medical attention. Performance claims reference peer-reviewed scientific literature in healthy athletic populations; individual outcomes vary and cannot be guaranteed.
Want to see how it would work for you? Book a free 20 minute demo call.